Tiger Tool Brake Anchor Pin Press

Operating Instructions

NOTE: In the event you are servicing a stamped spider, a punch and chisel may be required to remove the bushing.

Anchor Pin Removal

1. Install the Centering Bushing onto the back side of the Anchor pin shoulder.
2. Position the C-frame over the anchor pin (and centering bushing) and tighten
   the forcing screw by hand until the anvil makes contact with the front side of the
   anchor pin.
3. Apply force with a ¾” impact wrench until the anchor pin has been removed (Note: centering bushing may push out of the C-frame, this is normal)

Bushing Removal

1. Install the magnetized bushing adapter on to the anvil.
2. Position the C-frame over the bushing in the spider so the “step” in the bushing
   adapter seats inside of the bushing.
3. Apply force with a ¾” impact wrench until the bushing has been removed.

Preventative Maintenance

• Keep forcing screw clean and lubricated at all times with SAE 30 lube for the threads.